|
|||||||
|
|
|
|||||
|
|
|||||||
In this step it involves removing the two decks from the boat. When this is done the inside of the hull is coated with epoxy mixed with something like talcum powder until you get a mixture when held on a stick it will not run something like toothpaste. When the epoxy sets it will take all the flex out of the planks and then the outside of the hull can be sanded without the planks moving around.
I find it especially good because I can use my Orbital sander on it.
When the epoxy has been put on mine I will add the photo's.
|
Step
|
|
..
|
..
|